Aluminum stop for BETA400 and LINCE

Aluminum stop to limit the opening of the gate. Compatible with BETA400 and LINCE motors.

€14.00 (com IVA)

Partilhar

Dados do produto

Dados do produto

Referência TO644105

Produtos relacionados

Não há itens

Is it difficult to install an automation?

The installation of most engines is very simple, you will need to r some tools, most probably , have in your house.

The automation control unit is sent as prepared as possible, only in some cases it may be necessary to program the door 's shut-offs in order for the engine to adapt to its shape, sensitivity and strength to be exercised , but do not worry , the installation manuals are very clear and our technicians are helping you if you need them and , in some products, we have videos demonstrating how to install .

What is a limit switch?

The limit switch is an electromechanical device that is used in the installation of gates to indicate to the engine the stopping point in the opening and closing of the gate.

Which motor is the most suitable?

It is always advisable to choose an engine that has superior strength, since the gate drive conditions are not always the same, depends on the hardness of the course, the effort required to start moving it, etc.

A swing gate is the size of sheet to be taken into account, as well as the wind hitting against the sheet exerting a counterforce.

And if the electricity fails?

All engines have the possibility of manual opening and, in the case of a 24 Vdc motor, have a backup battery that allows the engine to work without electricity on average 20 more maneuvers.

I have an old motor and I want to replace it. The electronic central and remote controls I have are currently compatible with your motor?

Usually all engines are compatible with most electronic plants and vice versa, if you still have questions, you can send us pictures of your current installation, so we can recommend exactly if you can use the old material with new or you need to change any of the components.

How to install a swing gate motor?

The motors should be placed at the gate respecting their quotas installation (check installation manual for this step is very important). To fix the engine back can opt for the screwing or welding, according to the pillar of the material. The front end must be fastened to the door leaf, also welding or bolting, as preferred, using the motor mounting brackets. After that, just connect the motor to the electronic central and make the programming of the end-of-course.

Também lhe pode interessar (12)