Box with screws to rack- MCP24

Box with 24 screws and 24 washers to 4m CRM5 rack.

€4.00 (com IVA)

Partilhar

Dados do produto

Dados do produto

Referência TO644086

Marca:

Produtos relacionados

1m nylon gear rack with steel interior - CRM5

€9.00 (com IVA)

Is it difficult to install an automation?

The installation of most engines is very simple, you will need to r some tools, most probably , have in your house.

The automation control unit is sent as prepared as possible, only in some cases it may be necessary to program the door 's shut-offs in order for the engine to adapt to its shape, sensitivity and strength to be exercised , but do not worry , the installation manuals are very clear and our technicians are helping you if you need them and , in some products, we have videos demonstrating how to install .

What is a limit switch?

The limit switch is an electromechanical device that is used in the installation of gates to indicate to the engine the stopping point in the opening and closing of the gate.

Which motor is the most suitable?

It is always advisable to choose an engine that has superior strength, since the gate drive conditions are not always the same, depends on the hardness of the course, the effort required to start moving it, etc.

For example, for a sliding gate should take into account your weight, but it is also very important to consider whether the sliding gate occurs easily. If it is difficult to push the gate and does not slide well, you choose to apply to a motor support more weight, so that it has sufficient force to move the gate.

And if the electricity fails?

All engines have the possibility of manual opening and, in the case of a 24 Vdc motor, have a backup battery that allows the engine to work without electricity on average 20 more maneuvers.

I have an old motor and I want to replace it. The electronic central and remote controls I have are currently compatible with your motor?

Usually all engines are compatible with most electronic plants and vice versa, if you still have questions, you can send us pictures of your current installation, so we can recommend exactly if you can use the old material with new or you need to change any of the components.

How to install a sliding gate motor?

To install a sliding gate motor, the motor must be placed on the floor, on top of a concrete foundation, fixed with screws or welded, and then place the gate steel or nylon rack. Note that the nylon rack is only suitable for motors up to 800 kg. To adjust the end-of-course, connect the motor to the electronic central and make the necessary settings.

Também lhe pode interessar (12)

Box with screws to rack- MCP24

Menu

My account

Pesquisa

Partilhar